Your Cart: €0.00

Spend €116.00 more for free shipping!

View Cart and Checkout
Castle Creations Capacitor Pack - 8S Max (35V) - 2240Uf
Castle Creations Capacitor Pack - 8S Max (35V) - 2240Uf
Castle Creations Capacitor Pack - 8S Max (35V) - 2240Uf
Castle Creations Capacitor Pack - 8S Max (35V) - 2240Uf

Castle Creations Capacitor Pack - 8S Max (35V) - 2240Uf

Brand: Castle Creations

Part No: P-CC011-0148-00

40.50 RRP €41.75
Pre-Order

The Castle Creations Capacitor Pack 8S Max (35V) – 2240µF (P-CC011-0148-00) is designed to reduce ripple voltage in brushless power systems, easing the load on your ESC’s on-board capacitors. With four 560µF capacitors (2240µF total) rated at 35V, it supports LiPo setups up to 8S and helps maintain cleaner power during hard acceleration and when battery wires are longer than standard.

Key Features

  • 2240µF total (4 x 560µF) capacitor bank rated at 35V
  • Helps reduce ripple voltage and stress on ESC capacitors
  • Supports LiPo battery systems up to 8S
  • Helps offset ripple introduced by adding up to approximately 12 inches of battery lead length
  • Recommended for high-demand use such as hard collective pulls, drag racing, and high-speed runs

Suggested Compatibility & Applications

  • Suggested compatibility: brushless power systems using LiPo batteries up to 8S
  • Helicopters: highly recommended for 500-class and smaller, where Y-harnesses/long leads and aggressive collective inputs are common
  • Surface vehicles: useful in high-performance RC cars and trucks (e.g. drag racing and speed running)
  • Fixed-wing aircraft: beneficial where battery-to-ESC leads are extended beyond typical lengths

Specifications

  • Capacitance: 2240µF total (4 x 560µF)
  • Voltage rating: 35V (8S LiPo max)
  • Height: 22.1mm
  • Length: 45.7mm
  • Width: 19.8mm

Installation Notes

  • Install as close to the ESC as possible for best effect
  • Multiple CapPacks may be used in demanding applications
  • Castle controllers with data logging can report ripple voltage; peaks should be under 10% of total pack voltage
  • For battery systems greater than 8S (over 35V), use the 880µF 50V CapPack
CC CapPack is useful in all brushless motor applications, where it serves to give just that little boost needed to overcome ripples in the battery voltage caused by hard acceleration or long battery wires. Ripple voltage is hard on an ESC - adding the CC CapPack can help reduce the load on the controller's on-board capacitors. This CapPack uses four 560µF, 35V capacitors totaling 2240µF, which increases its ripple reducing capabilities.It can be used with LiPo batteries up to 8 cells. If your batteries are greater than 8s (35V) then you will need the 880µF, 50V CapPack.

Helis:
CC CapPack is highly recommended for all 500 class and smaller heli applications where Y harnesses and long wires can bleed voltage, and hard collective pulls can strain even the most powerful batteries.

Surface Vehicles:
With their high torque requirements - going from 0 to 100% throttle isn't easy on controllers or batteries - RC cars and trucks put enormous loads on brushless power systems. Use CC CapPacks in high performance applications (IE drag racing and high speed runs) to help your system power through the abuse.

Fixed Wing Aircraft:
Larger electric power systems lead to larger electric powered aircraft, and sometimes the distance between the battery pack and the ESC grows beyond the length of the wires installed on the components. Adding wire also adds inductance, which can increase the ripple voltage in a system. CC CapPack essentially negates the ripple caused by the addition of up to 12 inches of length to the battery wires.

Note:All Castle controllers with data logging capabilities can report the ripple voltage they encounter during use. Ripple voltage peaks should always be less than 10% of the total pack voltage; the smaller the ripple voltage the better. If an application exhibits more than 10% ripple voltage under peak loads, the user should consider using higher discharge (C Rating) batteries, shorter wires, higher current connectors, better gearing or a smaller load.

Multiple CapPacks may be used in an application. They should all be installed as close to the ESC as possible.


Castle Creations Capacitor Pack - 8S Max (35V) - 2240Uf Specifications
  • Height: 22.1mm
  • Length: 45.7mm
  • Width: 19.8mm


Key Info:
  • Brand: Castle Creations
  • Part No: P-CC011-0148-00
  • Barcode: 819326012136
Standard Shipping

£3.95 to most of the UK

Express Shipping

£6.95 to most of the UK

Worldwide Shipping

Available at checkout

Reviews
No specific product reviews yet, why not write one?
WRITE A REVIEW
All reviews are subject to moderation
No questions yet, why not ask one?
ASK A QUESTION
Get early access to deals and new arrivals.
Use this form to ask us a quick one sentence question about this specific product. Do not enter anything you would not like displayed on our site.

For more in depth queries, please contact us.