Vanquish Currie Portal F9 SCX10-II Rear Axle Clear

The Vanquish Currie Portal F9 SCX10-II Rear Axle (Clear), part number SCH-VPS08361, delivers a significant performance boost for rock crawlers by raising ground clearance and adding portal gear reduction at the wheels. With an increase of approximately 13mm under the axle centre and an internal portal reduction, it offers smoother, more controlled crawling while easing load on upstream drivetrain components.

Engineered for durability and precision, the Currie F9 Portal rear axle integrates the portal boxes into the housing for maximum clearance and a clean, scale look. It includes a Vanquish AR44 machined gear set, a complete Fast Eddy Bearings kit, and robust chromoly internals for strength. One Piece Bearing Retainers (patent pending), double shear shock mounts and increased upper link clearance contribute to reliable suspension travel and consistent performance on challenging terrain.

These axles come with the parts needed to assemble a complete rear axle. Optional portal gear sets allow tuning from the stock 1.67:1 reduction to a 1.4:1 overdrive ratio (overdrive sets are recommended for front axle use only).

Features

• Integrated portal box for maximum end-clearance and a realistic appearance
• Portal gear reduction of 1.67:1 (18/30); optional 1.4:1 overdrive (20/28)
• Overall axle reduction of 6.26:1 with the stock portal ratio
• Approx. 13mm increase in ground clearance
• Hex-to-hex width: 7.66 inches (about 5mm wider than a stock AR44 with narrow hex)
• Chromoly inner rear axle shafts with triple bearing support
• Chromoly stub shafts with 6mm at the drive pin, tapering to 5mm thread
• Chromoly spool
• Aluminium 12mm hex with set screw
• Complete Fast Eddy Bearings kit
• Licensed by Currie Enterprises
• One Piece Bearing Retainers (patent pending)
• Double shear shock mounts
• Upper link mounts built into the third member with increased link clearance

What’s Included

• Components required to assemble a full rear axle

Suggested Compatibility

• SCX10-II–based vehicles and platforms using Axial AR44 axles (using stock links)
• Axles should be used in pairs; matching front and rear portal axles are recommended
• Not suggested for the VS4-10 Pro

Fitment Notes

• Vanquish 1.9 wheels: use a 350 SLW hub or greater
• Incision wheels: use #4 hub or greater
• Other wheel manufacturer offsets may vary
• Overdrive portal gear sets are recommended for the front axle only