Vanquish Incision Series 3 Light Kit

The Vanquish Incision Series 3 Light Kit (SCH-IRC00452) is engineered for a clean, scale installation on the VS4-10 Phoenix and VS4-10 Origin Classic, integrating with the moulded inner fenders. It delivers powerful illumination with moulded front light buckets, red LED tail lights and white rock lights, all managed by an LED controller offering manual and AUX-channel control.

Features

• Moulded front light buckets with high-powered LEDs and heatsinks
• Red LED tail lights
• White LED front/rear inner fender rock lights
• LED light controller with manual on/off and AUX receiver channel control
• Headlights powered via 2–3S LiPo balance plug on the light controller
• AUX control and red LED headlights powered via RX plug
• Direct-fit front headlight housings for the Phoenix body grille

What’s Included

• 2x moulded front LED headlight housings with heatsink; direct-fit/bolt pattern for Phoenix body grille
• 2x 5 mm red LED tail lights
• 4x PCB LED rock lights for use with moulded inner fenders (use 4 on Origin, use 2 on Phoenix)
• 1x LED controller with required power plugs
• Parts box

Suggested Compatibility

• Vanquish VS4-10 Phoenix body set
• Vanquish VS4-10 Origin body set

Installation Instructions

• Remove stock light buckets from the body set.
• Mount the included light assemblies to the body using the existing 1-64 hardware.
• Install the red LED tail lights into the stock VS4-10 rear LED housings.
• Mount the LED controller to the chassis and connect body-mounted LEDs using the 4-pin connector.
• Install chassis-mounted rock lights to the inner fenders using hardware and brackets from VS4-10 kits.
• Connect LED plugs to the light controller.
• Connect the light controller to a 2S or 3S LiPo battery for the headlight power source.
• Connect the light controller to the receiver; for full functionality, use an open auxiliary channel.
• Program the transmitter’s AUX channel for two positions (On/Off) with endpoints at maximum.
• Set the controller’s 3-position switch to the middle position to enable AUX channel control (left: Off / middle: AUX / right: On).

Installation Tips

• Attach the LED controller and rock lights to the chassis first.
• Route headlight and tail light wires to the underside of the body and use the black 4-pin plug for easy body removal.
• Use the balance plug and JST connection for the power source, and the RX connection at the chassis for easy removal.
• Power notes: the JST source powers headlights and rock lights; the RX AUX powers tail lights. Connect both for full functionality.