XRay Diff Bulkhead - Horizontal Split Design (Hs) - Front/Rear - Set

The XRay XR362006 Diff Bulkhead HS Front/Rear Set brings rapid differential access and fine diff height tuning to your buggy. The horizontal split (HS) design lets you reach the differential by removing just four screws from the upper gearbox cover, while the lower section remains mounted to the chassis for quick setup changes and servicing.

An inline bushing system adjusts both the differential height and the alignment of the bevel drive gear. This geometry also reduces the front centre driveshaft angle to minimise friction and wear on CV joint components, improving overall driveline efficiency. Super-strong, narrow bulkheads provide extra clearance for redesigned suspension holders, expanding your setup range at both ends of the car.

Key Features

• Horizontal split (HS) bulkheads for fast access: remove 4 screws from the upper gearbox cover; lower section stays on the chassis.
• Inline bushing system adjusts differential height and bevel drive gear alignment.
• Reduced front centre driveshaft angle for less friction and wear on CV joint components and improved driveline efficiency.
• Front and rear application with strong, narrow bulkheads providing clearance for suspension holders and a wider setup range.

Suggested Compatibility

• XB4'21 (suggested compatibility)