
Dynamite 3rd Channel Kill Switch for Large Scale RC
Brand: Dynamite
Part No: DYNE1240
In Stock: Usually ships same day
- Kills your 2-cycle gas engine on command, loss of radio signal, low battery, or total battery power loss
- Comes ready to install — no soldering required
- Optically Coupled to isolate your ignition system from your radio system
- Built-in LED for easy-to-spot operational status
- 3-Channel Radio System Required
- Not Compatible with AVC-Equipped Receivers
Dynamite 3rd Channel Kill Switch for Large Scale RC Specfications:
- Part Type: Electronics
Secured by Stripe
- Brand: Dynamite
- Part No: DYNE1240
- Barcode: 605482587317
- Fitment: Option Part
This item is also listed in the following additional categories:
Standard Shipping
£3.95 to most of the UK
Express Shipping
£6.95 to most of the UK
Worldwide Shipping
Available at checkout
Reviews
No specific product reviews yet, why not write one?WRITE A REVIEW
Questions & Answers
We would recommend uninstalling everything and starting again as you will have a full warranty with that then.
Yes these come with an instruction manual.
I'm very sorry we only list this one kill switch, we found that with the AVC active you could not kill the engine from the transmitter ( please note this was a few years ago on much older recievers )
Yes that will work with a Losi 5IVE
Yes it would.
It'll work with pretty much any Futaba receiver. Please be aware that if you have a receiver with a stability control system, you may need to disable this for proper control.
A spektrum receiver with AVC (stability control) - something like say the SRS6000
We don't sell that model, so can't confirm 100% - however I've never seen a 1:5 scale model that this doesn't work with - so I'm sure it'll be fine.
You will need a spare third channel switch to use it from the transmitter.
Yes that should work fine with an HPI Baja
Yes, that's what it's designed for.
Yes, it works with pretty much any radio.
We have noticed however that you will need to disable Stability control systems if they are active on your receiver.
No, you require a 3 channel transmitter.
Yes this will work on the Maverick Blackout.
ASK A QUESTION
For more in depth queries, please contact us.