GBP
€ Euro
$ USD
Maverick Strada DT RED Brushless
Brand: Maverick
Part No: MV12628
In Stock: Usually ships same day
The Strada DT 4WD Desert Truck features a fully enclosed roll cage with cool integrated body panels painted that not only looks amazing, it provides additional protection for the chassis components. The Strada DT features a moulded tub chassis that provides durability and a stable and tough platform for a strong 4WD shaft drivetrain. Pre-built oil-filled shock absorbers and dual-wishbone independent suspension front and rear, give you supreme confidence on all driving surfaces. The MS-22 servo controls the steering through a dual-point steering system that features an integrated servo saver to protect the servo against crash damage. The Strada 4WD drivetrain uses efficient ball bearings throughout to give drivers maximum runtime and efficiency, and features a molded gear cover to keep dirt and debris away from the gears. Front and rear gear differentials easily transfer the motor's power to the pre-mounted tires at all four corners.
Maverick Strada Red DT Kit Features:
- MM-22BL 3215KV brushless motor with 4mm gold-plated plugs
- MSC-30BL-WP brushless FWD/Brake/Reverse Waterproof ESC
- MBP-26 3000mAh Ni-MH battery
- MS-22 high-strength steering servo
- MTX/MRX-243 2.4GHz transmitter and receiver with built-in failsafe
- Moulded tub chassis with optimised weight distribution
- Fully adjustable suspension
- Battery strap will accept both stick packs and side-by-side cells
- 4 oil-filled rebuildable shocks with coil-over springs
- Aluminum gold anodised shock tops
- Fully independent double wishbone suspension
- Tough C-hub front steering knuckles
- Tough efficient 4wd shaft drive train
- Fully ballraced drive train
- Aluminum gold anodised upper deck
- Aluminum gold anodised lightweight centre shaft
- Pre-cut body factory-finished
- Fully adjustable turnbuckles all round
- Front and rear moulded bumpers
- Twin-point steering with integrated servo saver
- Moulded 1-piece rear wing
- Moulded protective gear cover
Includes:
- 7.2V 3000mAh Ni-MH battery stick pack
- Multi-region wall battery charger
Items Required:
- 4 x AA Batteries
Specification:
- Length: 470mm
- Width: 260mm
- Height: 155mm
- Wheelbase: 270mm
- Weight: 1.75kg
Secured by Stripe
- Brand: Maverick
- Part No: MV12628
- Barcode: 5050864020879
- Scale: 1:10
- Build Level: Assembled (RTR)
- Vehicle Type: Buggy
- Power Source: Electric - Brushless
- Surface Type: Off Road
Free Shipping
This item is over £100, so qualifies for free standard UK shipping!
Express Shipping
Upgrade to next day from £3
Worldwide Shipping
Available at checkout
Reviews
Great 1/10 buggy.. couple of minor issues.. the aerial is positioned above the prop-shaft so take care as excess length can rub on the shaft all the time .. also the bottom righthand corner of the roll-cage fouled the battery retention clip when lowering the body twisting it . As it is difficult to get in to deflect the cage around it while lowering the body I bent the head of the battery clip up to give clearance.. also the cage front right lower corner fouled the tub but can easily be pushed in after fitting to sit properly. I hope these tips help as it is great value for money and excellent service from Wheelspin as usual.
WRITE A REVIEW
Questions & Answers
This is factory set and non adjustable, the toe in on the rear helps to keep the car going in a straight line.
Yes, in theory that's possible - you could take a look in the parts explosions and fit the required parts. They share a lot of common items
No this is not a car to run an 11.1 lipo on, it's just too powerful for the drive train etc.
1:10 Scale
it should be able to do around 35 mph.
The stock battery will take around 8 hours to charge on the stock charger and give around 10-15 mins runtime.
If you go for the better batteries/chargers in our combos, a 5000mah would give around 25-30 mins runtime and take around 45-50 mins to charge on a fast charger.
No
2S max on these
2S max on these
2S max
It all depends on the voltage, but on a 7.4 which is recommended it should be able to do around 35 mph.
ASK A QUESTION
For more in depth queries, please contact us.
Maverick Multi-Region 300Ma Mains Charger For 7.2V Battery (Tamiya-T-Plug) ** CLEARANCE **
Battery Cover
Battery Cover Post (2Pcs)
Round Head Screw M2X10 (10Pcs)
Mrx-244 Maverick 2.4Ghz 3Ch Receiver With Built In Failsafe
Front Axle (2Pcs)
27T Pinion Gear (0.8 Module) (ALL Strada EVO )
Steering Linkage (2Pcs)
Shock Ball Head (Strada EVO XB/SC)
Countersunk Cross Head Self-Tapping Screw M3X14mm (13Pcs)
Wheel Hex. (8Pcs)
Maverick Roll Cage Parts A/B
Rear Lower Arm Outer Pin (2Pcs)
Maverick Spare Wheel
Washer 5x10x0.2mm (10 pcs)